| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Shocks & Bushings for a Lift http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=162 |
Page 1 of 1 |
| Author: | Amarony [ Sat Jul 09, 2005 5:05 pm ] |
| Post subject: | Shocks & Bushings for a Lift |
So I'm thinking about doing a Rusty's coil lift but have seen a lot of posts about troubles with the bushings being the wrong size. Seems a lot of folks are having strange noises as a result and are continually re-torqing as a result. Would it be advantageous to do the Rusty lift but use different shocks? As far as I know Rancho's are the only shocks out there with the correct size. Or are there others? What do y'all think? Any advice is apprecited. |
|
| Author: | JJsTJ [ Sat Jul 09, 2005 5:07 pm ] |
| Post subject: | |
The Ranchos do work good, It is an option. Check to see if Rusty's will give you a credit on the shocks. |
|
| Author: | EagleVT94 [ Mon Jul 11, 2005 6:56 am ] |
| Post subject: | |
I know this has been mentioned a dozen times, but to save my searches, which part number were the Rancho shocks again? And which shocks are the problems on Rusty's lift? (Front or Rear?) I have the lift and its going on soon... Thanx. |
|
| Author: | Original Bigfoot [ Mon Jul 11, 2005 9:22 am ] |
| Post subject: | |
For me, it is the rear shocks making the noise. |
|
| Author: | skrracing [ Mon Jul 11, 2005 10:46 am ] |
| Post subject: | Here you go |
The Rancho rear shock that is correct is RSX17004. Just tighten them down very tight the first time and it should be a done deal. Hope that helps. later...Clint |
|
| Author: | vxla [ Mon Jul 11, 2005 7:18 pm ] |
| Post subject: | |
I have the shocks that came wtih Rusty's on; I put them on in August and have had no problems. The bushings were there in the package, too. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|