LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

question/idea
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=17530		 Page 1 of 1
Author:  raceinfan [ Sat Feb 10, 2007 10:03 am ]
Post subject:  question/idea
I have 2 rusty's .75 spacers that have been replaced with Rustys full coil lift now my question/idea is if I was to just cut the top half off that the strut sits in 1/4" could I just use that 1/4" piece for a clevis lift rather than buy the washers to level out the front ?????
Author:  jason thompson [ Sat Feb 10, 2007 10:09 am ]
Post subject:  Re: question/idea
raceinfan wrote:
I have 2 rusty's .75 spacers that have been replaced with Rustys full coil lift now my question/idea is if I was to just cut the top half off that the strut sits in 1/4" could I just use that 1/4" piece for a clevis lift rather than buy the washers to level out the front ?????



I am not sure what spacer you have but I think the one you are talking about is polly?
if so then I would think that would be a bad idea how ever there is n easy solution that was posted up here a while back its real easy
go to homedepot or where ever you can to buy some 1/4" thick by 3" wide alum flat bar but a 3" hole saw and a 2 1/8" I think hole saw
out the pcs you need ,make rings, I did it and it works good and was easy to do
bets and cheepest thing would be to get with a few others and split the cost
Author:  raceinfan [ Sat Feb 10, 2007 10:17 am ]
Post subject: 
yeah it's the polly spacer they sell, wasn't shure if it would work or not just a thought :?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/