Okay guys, and gals... i am going to be buying a hi-lift all-cast jack. my question is which size to buy? the 48" or 60"? I am not lifted, and will not be lifted until another 7 year/ 70k miles. so which should i go with?

A 48" is all you need, a 60" would be hard to carry around. Depending on the year of your Liberty a 48" might fit underneath the rear seat, although you do have to remove the base.

EDIT - Found this post from way back. Has some info about fitting Hi-Lifts in the KJ.

http://www.lostjeeps.com/forum/phpBB3/vie ... ft&start=0

EDIT Again - Hah, just realized that post started the exact day I bought my KJ, how funny.

Justin

_________________
2005 Blue KJ Renegade
Too big to fit into most LA parking garages.

anyone have pics of where they mounted their hi-lift inside their KJ?

I slid my 48" under the rear seat. The base is on the drivers side. I'll take some pics tonight.

_________________
2008 Xterra 4x4

1986 CJ7
Lots of custom stuff...

Gone, But not Forgotten...
2003 Sport - 'Fire Engine' Red
Detours KJ Backbone
Skids
Boulder Bars
JBA 4.5 A Arms
245/75/16 Wrangler Duratracs's on Cragar Soft 8’s
Spidertrax 1.25" Spacers
Superwinch LP 8500
Frankenlifted

I have the 60" along with the wheel kit and winch kit. I mount my on my Safari basket. Before I added the safari basket, I used to tie it on the Mopar Renegade roof basket.

_________________
LostRenegade - Lost # 477
2003 Jeep Liberty Renegade - Silver
Mopar Skids, Skid Row Tranny Skid, Boulder Bars, Frankenlift II, 60" Hi-Lift Jack, K&N 6x9 Air Filter, Magnaflow, Dertoit Locker, 245/75R16 BF Goodrich All Terrains, Al's A-Arms