LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Transfer Case Skid
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=2021
Page 1 of 1

Author:  Sean [ Mon Sep 19, 2005 2:46 pm ]
Post subject:  Transfer Case Skid

Here is the PDF file of the instructions... I still cant figure out how to get "Part B" into the frame using "Part A"


Any Ideas?

http://seanjen.com/files/skid.pdf


This is going on an 05 Renegade.
Thanks, Sean.

Author:  Cacher123 [ Mon Sep 19, 2005 3:05 pm ]
Post subject: 

That's easy if you have the right directions. Unfortunately all they gave u was a diagram and no literal instructions. Having just done this for the AllJs shelf I can point you to those directions:

http://www.youngs.org/kjparts/all-jrack.pdf

The info u want is on PAGE 4
The install is the same except they didn't give you any washers to put between the bolt (A) and the holding nut (also A). The washers just help to reduce the friction when u do the install.

Basically, u drill a hole (unless it's already there, which it may be in your case), insert the threaded insert which is on the end of that (A) bolt (which they call an install tool), hold the nut closest to the body where the insert is with one wrench to keep it from turning or pulling out, and tighten the bolt (A) with the other wrench.
This causes the insert to expand inside the hole. When it is tight you unscrew the bolt/install tool (A) and u r left with a threaded insert inside the previously empty hole. You repeat this for the other holes using the same bolt/instasll tool. When u r done these are where u will screw ure mounting bolts to.

Author:  Sean [ Mon Sep 19, 2005 3:14 pm ]
Post subject: 

where are those directions at... and will they help me?

Author:  Cacher123 [ Mon Sep 19, 2005 3:21 pm ]
Post subject: 

Go back to my post. I was editing it while u were typing.
Chris

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/