Just got my ARB bumper and wanted to know how hard it will be to install ? Any help would be great !

_________________
Stand Out !!!

will take 3-5 hours.

not too hard, did mine 2 weeks ago.

_________________
Neo Film + Video
http://www.neofilm.tv

2004 3.7L KJ
BFG AT's
ARB Bull Bar
Frankenlifted
Hella 500's
Mopar Skids

The instructions with the ARB bull bar are great, easy to understand and simple. I got mine on in about 3 hours too, and the hardest part for me was trying to get that little piece of plastic moulding to stick on the cut edge of the fender. I ended up using a waterproof contact cement to get the bugger to stick. Tip: sand the edge of the fender a bit if you're going to put the trim on. Have fun, helps to have another set of hands when lifting the bumper on...Are you loading a winch into it?

I wish the TJM came with better instructions. The instructions were adequate but they should have been much better. They were not clear about tools to be used, which hardware goes where, and how to trim the fender linings. The TJM take about 8-10 hours to install because of the extensive fender trimming and wiring. Fender trimming takes forever if you do it right. The TJM can easily be done by one person.

_________________
2005 CRD , Moab Rims, 245/75/16 Goodyear M/T
RL rear bumper, TMJ Front bumper, Frankenlinft,
*TOTALED*

1985 Mitsubishi Pickup SP 2.3 Turbo Diesel Watercooled turbo,4D56 ported head,
12" Suspension Lift with JK Rubicon axles, Elockers, 5.13's, Fox coilovers, Atlas 5.0, Rock Lizard supersliders

1996 Lexus LX450 -locked and lifted-

Took me around 7 hours...but I'm a desk jockey with limit mechanical skills.

_________________
02 Shale Green KJ Sport 4x4
Rusty's 2.5" Coil Spring Lift, ARB BullBar, LT 245/75/R16 BFG AT's, etc.

When I did mine it took about 3 hours max and that was even stopping to have an ice tea or two. Its not hard just take your time. Cutting the fenders is the hardest and my one screw up was caused by my wife! At least I blame it on her!!

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited