So, as I've mentioned before, my transfer case keeps slipping from 4-LO to N on occasion. I noticed tonight that I could hold up on the handle to keep it from popping out. Is there an easy way to tighten this up?

_________________
Ron


"There are few problems in life the liberal application of duct tape can't solve."

You may need to adjust your linkage,sounds like it is not fully engaging into 4-lo.Under the KJ near the front t-case output(to front diff) is the linkage,it has a adjustment on it.It's hard to explain with out showing you but once you look at it it is pretty easy,disconect the linkage,make sure the t-case shofter(little shaft with arm sticking out of the t-case is fully turned torwards the front of the KJ) and adjust the linkage to match the distance,rehook up,and then test operation.Hope this helped a little.

Thanks, I'll take a look at it after work tonight.

_________________
Ron


"There are few problems in life the liberal application of duct tape can't solve."