LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

another lift question
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=21866
Page 1 of 1

Author:  bigmd [ Thu Jun 21, 2007 4:17 pm ]
Post subject:  another lift question

are there any factory springs from other trucks that can be used on the liberty to give it some lift?not looking for that much.

Author:  spoonplugger1 [ Thu Jun 21, 2007 7:52 pm ]
Post subject: 

Explain what your looking for, and how much money you have to spend.
Your first post is not helping you with the Liberty lovers here, hence no answers. Sounds like you want the junk up your rig just to get a little lift instead of getting a good result for your efforts. For instance the clevis lift doesn't give a lot of a lift,but is quick and cheap without damaging the good handling and safety of the rig.

Author:  chefdab [ Fri Jun 22, 2007 5:39 pm ]
Post subject: 

He's probably looking for something I've seen on some other boards. Some guys use the coils out of a v-8 ZJ to give a little lift to a four banger TJ. Or I recall someone using the coils out of a Crown Victoria in their TJ to get lift. This way you can get the coils cheap from a junker. I don't think anyone has even tried anything like that on a KJ so I wouldn't know if anything would even fit.

Author:  myjeepwalks [ Sat Jun 23, 2007 9:55 pm ]
Post subject: 

Get some springs from an 02' about 3/4 inch higher. Also throw an extra isolator in the rear and do a clevis in the front. Unless you already have an 02' then nevermind :D Some one here was giving away some free ones somewhere if i remember correctly.

Author:  bigmd [ Sun Jun 24, 2007 6:34 am ]
Post subject: 

whats a clevis?

Author:  moose [ Sun Jun 24, 2007 9:50 am ]
Post subject: 

bigmd wrote:
whats a clevis?

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=15164
Look about a quarter of the way down, or read until you find it.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/