Look down the page on the main page, there is a write up in the tech articles section.
Here is a link
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=11303
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Wheel Bearings http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=22256 |
Page 1 of 1 |
| Author: | pg2676 [ Thu Jul 05, 2007 12:15 am ] |
| Post subject: | Wheel Bearings |
Anyone have a procedure for changing the front and rear wheel bearings? Any special tools needed if I do it in my driveway? |
|
| Author: | Jeepjeepster [ Thu Jul 05, 2007 1:46 am ] |
| Post subject: | |
I cannot remember what kinda bolt those have on it, but I know it doesnt take a regular socket. |
|
| Author: | Dje Ryu [ Thu Jul 05, 2007 2:16 am ] |
| Post subject: | |
35mm deep-well socket to get the axle nut off. After that, I'm not sure. |
|
| Author: | USAFCOP [ Thu Jul 05, 2007 2:23 am ] |
| Post subject: | |
Look down the page on the main page, there is a write up in the tech articles section. Here is a link http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=11303
|
|
| Author: | Jeepjeepster [ Thu Jul 05, 2007 9:43 am ] |
| Post subject: | |
You can see the bolt I was talking about in those pics. Idk, I may of been BS'ing you.. For some reason I thought it was a torx.. 
|
|
| Author: | tjkj2002 [ Thu Jul 05, 2007 11:10 am ] |
| Post subject: | |
To remove the front unit bearing assembly you will need a 35mm deepwell socket(axle nut) and a E14 socket for the 3 unit bearing bolts that hold it in the knuckle.The rear wheel bearings will require a slide hammer with the bearing puller attachment. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|