LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Rock Lizard Rear Bumper Install Instructions
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=22749		 Page 1 of 1
Author:  unixxx [ Mon Jul 23, 2007 1:27 pm ]
Post subject:  Rock Lizard Rear Bumper Install Instructions
Does anyone know where I can find Marty's installation thread on the forum? Search isn't helping me....
Author:  pokefan [ Mon Jul 23, 2007 1:43 pm ]
Post subject: 
HERE'S the best I could find.
Author:  Rock Lizard [ Mon Jul 23, 2007 2:49 pm ]
Post subject: 
Here you go. I'm almost finished with them, so just refresh the page until they are complete. Should be plenty already to get you started.

http://www.rocklizardfabrications.com/k ... ctions.htm
Author:  0311_DoC [ Mon Jul 23, 2007 2:52 pm ]
Post subject: 
what about the 05-07 instructions? are they different?
Author:  Rock Lizard [ Mon Jul 23, 2007 2:55 pm ]
Post subject: 
0311_DoC wrote:
what about the 05-07 instructions? are they different?


exactly the same for all years 02-07.
Author:  Rock Lizard [ Mon Jul 23, 2007 3:20 pm ]
Post subject: 
OK, all done. If I missed anything, or if something is not clear enough, please let me know so I can make improvements.
Author:  JJsTJ [ Mon Jul 23, 2007 3:54 pm ]
Post subject: 
FWIW, I cut the notches but then just bent the sheet metal back, folding it up under toward the bolt holes and flattening it w/ a hammer. It fits and works fine and keeps you from cutting a chunk out of the rear pinch weld.
Author:  USAFCOP [ Mon Jul 23, 2007 6:17 pm ]
Post subject: 
RL Instructions:
Quote:
7. Support gas tank skid with jack, remove all 6 bolts (3 per side) with an 18MM socket, remove stock hitch if equipped. Forward most bolt on passenger side may need to be removed with an 18MM wrench if exhaust pipe is in the way.


Great excuse to buy a set of those ratcheting wrenches :twisted: Works a lot easier than re-adjusting a standard wrench... Especially with as many times I have had to install and remove one of these :roll:

New tools are as good as well, nevermind... :P :?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/