Or do I hace to run OME HD lift kit front and rear in order to have a correct stability of the vehicle in a high way?

You can run OME Heavy DUty Fronts and Skyjacker rear with no problems, I have two sets of rear springs, I tow a lot so I have a set of OME Heavy Duty rears for towing and a set of Rustys for the other times when not hauling, I can switch them out in no time at all. So yes you can do that

Tom

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Great question. I was wondering the same thing. I paln on switching to the Frankenlift front and adding the OME N132L to the skyjacker rear. Hopefully this set-up will work well. Will I need spring isolator pads to sit level?

_________________
TRADED 04' Renegade
Franken lift front/ Skyjacker rear
JBA uca's
245 Firestone Destinations

2015 Jeep Cherokee Trailhawk (stock)


2014 Yamaha FZ-09
1999 Yamaha VMax
LOSTKJs #124

That's what I have on my CRD, I swapped out the skyjacker in the front for OME and kept the skyjacker in the rear, since there was nothing wrong with the rear.

_________________
05 KJ CRD Limited

On my rear set up I have had 2.5 inch pucks/ Heavy Duty OMEs and also Rustys, all ride a little different, each have their good points but all will work!

Tom

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

thanks for your support