| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Gearing suggestion http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=24115 |
Page 1 of 1 |
| Author: | chefdab [ Thu Sep 06, 2007 3:03 pm ] |
| Post subject: | Gearing suggestion |
I was just reading on another Jeep board about gearing and it was stated that the early model Dana 30 axles used a longer pinion than the current version on the TJ. Isn't the problem with new gears for the KJ that the Dana 30A uses a longer pinion than the other Dana 30 gear sets? I don't know the specifics but would it be possible to use a gear set that is marketed for a CJ Dana 30 in the KJ? Someone with a little more mechanical knowledge want to check to see if the pinion lengths are the same. Just thought maybe it might be a possible solution to the shortage of gearing options for the KJ. |
|
| Author: | Dje Ryu [ Thu Sep 06, 2007 9:19 pm ] |
| Post subject: | |
Interesting. I have the tools to measure them but I'd need the pinion gears from each. If it works, though, you may have a few hundred very thankful fans. Nice find, either way! I'll ask a few of my cj buddies if they happen to have any D30 pinion gears around and get some measurements, if I can. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|