LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Can anyone tell me the OME927 spring length ?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=24425		 Page 1 of 1
Author:  cherokj [ Mon Sep 17, 2007 10:02 am ]
Post subject:  Can anyone tell me the OME927 spring length ?
I mean before installed. Just to compare to the stock ones.

Thanks
Author:  tommudd [ Mon Sep 17, 2007 11:01 am ]
Post subject: 
15 1/4 inches, just happen to have one laying close by Thanks ARB/OME!! :lol:
of course that means nothing due to you can have say that OME 927 that measures 15 1/4 inches and then another one that measures the same but if it is only 275/300 lbs compared to the 400 for the 927 then the heighth you end up with will be different. spring rate makes a huge difference after you get them on a vehicle. Not sure if that was where you were going with the question but.........
Author:  ARBSeth [ Mon Sep 17, 2007 12:03 pm ]
Post subject: 
927's are 394 MM's @ 400#'s
926's are 392 mm's @ 375#'s
925's are 385 mm's @ 375#'s
All are 16mm bar diameter
Inches aren't precise enough to tell the difference if you're trying to identify a coil. Use mm's.
Author:  tommudd [ Mon Sep 17, 2007 12:10 pm ]
Post subject: 
Beat me to it Seth had just got my "other" measuring tool to do mm's

tom
Author:  cherokj [ Mon Sep 17, 2007 5:50 pm ]
Post subject: 
Thanks a lot, guys.
The importance of length is that you can have more extension of the strut ( if the shock is longer too ). I mean, you keep the down suspension travel.
That means that the NS131 have a longer extended length than stock front shocks as they are designed to be used with the stock upper plates...am I wrong?
Author:  ARBSeth [ Mon Sep 17, 2007 6:17 pm ]
Post subject: 
That would be correct
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/