Can anyone tell me the OME927 spring length ?

cherokj · **Joined:** Fri Sep 16, 2005 2:03 pm **Posts:** 64

I mean before installed. Just to compare to the stock ones.

Thanks

tommudd · **Posted:** Mon Sep 17, 2007 11:01 am

15 1/4 inches, just happen to have one laying close by Thanks ARB/OME!! :lol:

of course that means nothing due to you can have say that OME 927 that measures 15 1/4 inches and then another one that measures the same but if it is only 275/300 lbs compared to the 400 for the 927 then the heighth you end up with will be different. spring rate makes a huge difference after you get them on a vehicle. Not sure if that was where you were going with the question but.........

ARBSeth · **Posted:** Mon Sep 17, 2007 12:03 pm

927's are 394 MM's @ 400#'s
926's are 392 mm's @ 375#'s
925's are 385 mm's @ 375#'s
All are 16mm bar diameter
Inches aren't precise enough to tell the difference if you're trying to identify a coil. Use mm's.

tommudd · **Posted:** Mon Sep 17, 2007 12:10 pm

Beat me to it Seth had just got my "other" measuring tool to do mm's

tom

cherokj · **Joined:** Fri Sep 16, 2005 2:03 pm **Posts:** 64

Thanks a lot, guys.
The importance of length is that you can have more extension of the strut ( if the shock is longer too ). I mean, you keep the down suspension travel.
That means that the NS131 have a longer extended length than stock front shocks as they are designed to be used with the stock upper plates...am I wrong?

ARBSeth · **Posted:** Mon Sep 17, 2007 6:17 pm

That would be correct

Can anyone tell me the OME927 spring length ?

Who is online