Surprisingly, There's not much to it. Here's my pinch weld trimmed and pounded over:
and just about half an inch off the plastic splash guard that runs along the bottom of the bumper fascia.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Where to Cut. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=24819 |
Page 1 of 1 |
| Author: | TexasSara [ Fri Sep 28, 2007 12:44 pm ] |
| Post subject: | Where to Cut. |
dose anyone have a good pic of where to cut the inerfender of an 05 Kj??? I have a 2" daystar lift and 1.25 wheel spacers with 245's I just want to make quick work of the triming. thank s Sara and Nate |
|
| Author: | Gringo Loco [ Fri Sep 28, 2007 1:42 pm ] |
| Post subject: | |
Hey Sara are you and Nate going to Katemcy Rocks this weekend? If so Jasonk and I will be there. Sorry I can't help with the inner fender cutting, I never had to do any to my 05. |
|
| Author: | elephantrider [ Fri Sep 28, 2007 3:31 pm ] |
| Post subject: | |
i removed my entire fender wells ... its not hard, just comes right out if you take the rivets out of the outer fender lip. i tried to be careful and cut just what i needed to, but found out the hard way that its easier to remove the whole thing. |
|
| Author: | ctr05kj [ Fri Sep 28, 2007 4:20 pm ] |
| Post subject: | |
I miss Katemecy !!! You have a great wheeling park down there in the hill country. |
|
| Author: | Dje Ryu [ Fri Sep 28, 2007 9:47 pm ] |
| Post subject: | |
Surprisingly, There's not much to it. Here's my pinch weld trimmed and pounded over:
and just about half an inch off the plastic splash guard that runs along the bottom of the bumper fascia.
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|