| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rusty's Off-Road Rock Panel Skids/Rock Rails Question? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=24916 |
Page 1 of 1 |
| Author: | Cobalt-60 [ Mon Oct 01, 2007 11:49 am ] |
| Post subject: | Rusty's Off-Road Rock Panel Skids/Rock Rails Question? |
Anybody know what the proper size drill bits are to drill the starter holes for the "self-tapping" screws on the frame and pinch weld mounts for a set of these? |
|
| Author: | JJsTJ [ Mon Oct 01, 2007 12:59 pm ] |
| Post subject: | |
Not sure on Rustys but the All J Boulderbars use an F size bit which can be tough to find. Sears and some True Value stores usually carry them. |
|
| Author: | Cobalt-60 [ Tue Oct 02, 2007 9:56 am ] |
| Post subject: | |
Bump Anybody else have any ideas? |
|
| Author: | wildrussian [ Tue Oct 02, 2007 9:59 am ] |
| Post subject: | |
Send Rusty an email at rusty@rustysoffroad.com he will tell you exactly what you need. he is pretty good at emailing back too. |
|
| Author: | Grape [ Tue Oct 02, 2007 10:43 am ] |
| Post subject: | |
You can call them as well. You can even ask to speak to rusty. If you happen to get Zach on the phone that is Rusty's Son he can help as well. Phone: (256) 442-0607 |
|
| Author: | todaysrover [ Wed Oct 03, 2007 1:25 am ] |
| Post subject: | drill size |
Self tapers, no pre-drilling, I used an 18 volt ryobi impact, they went right in. hope this helps |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|