Help with an evic and tpms.

Dtmf13 · **Posted:** Tue Dec 18, 2007 10:55 pm

Hi all,

I've added an Evic with TPMS on my 03 KJ a few months ago and was working fine except for the "Service Tire pressure system" message each time a started the engine. I finally installed and trained all 5 sensors yesterday but I still get the same message ( yes I drove at least 15 miles). What I'm not sure about, is that all 5 were trained and shows "Training complete" but my spare is not showing only the 4 other tires. Should I see the spare all the time?

Any help would be greatly appreciated.

Marc

Jeepjeepster · **Posted:** Wed Dec 19, 2007 12:04 am

The spare doesnt show on the screen. It only tells you if the spare is low or high on air.

Not to sure why it still tells you to service it if all the pressures are showing..

Dje Ryu · **Posted:** Wed Dec 19, 2007 1:00 am

maybe the spare isn't training? not sure, just throwing out an idea.

SoDakJeep · **Posted:** Wed Dec 19, 2007 3:28 am

put the spare on ad drive for a couple miles then change back at least it worked on mine

JHCRASH · **Posted:** Wed Dec 19, 2007 5:24 am

SoDakJeep wrote:

put the spare on ad drive for a couple miles then change back at least it worked on mine

This is what I would also say to do.And ya only the four show all the time.

Jeepjeepster · **Posted:** Wed Dec 19, 2007 1:04 pm

The evic will not retain the training if all 5 sensors are not there and recognized. It must know its there if its saying training complete.

Dtmf13 · **Posted:** Fri Dec 21, 2007 8:54 pm

I guess the only thing left is to swap the spare and drive a bit. Thanks for the help.

Help with an evic and tpms.

Who is online