| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rusty's Skids Install http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=31500 |
Page 1 of 1 |
| Author: | JeepinMaxx [ Sun Apr 13, 2008 2:45 pm ] |
| Post subject: | Rusty's Skids Install |
Installed the Rusty's gas tank skid and a rear hitch. Also sand blasted re-painted and re-installed Rusty's rock rails.. The gas tank skid is pretty beefy. It fit perfect. You have to remove the factory tow hook (now for sale). One great tip I got was to run a 12mm x 1.75 tap through all of the mounting holes 1st to clean the threads. That way I was able to finger tighten all the bolts I'll post a few pics: Here's Rusty's rock rails after six years of abuse!
After sand blasting and priming
The new skid:
Mounting points on the drivers side (notice the close fit of the hitch and the skid plate)
Installed (the ATV jack works great for this job - also notice the wheels are off the ground and the skid is supporting all the weight...)
|
|
| Author: | john jr [ Sun Apr 13, 2008 3:18 pm ] |
| Post subject: | |
Looks good |
|
| Author: | Jeepjeepster [ Sun Apr 13, 2008 3:50 pm ] |
| Post subject: | |
Looks nice. Be careful with that hitch. Since it doesnt use all 6 mounting points I would tow anything close to 5k with it. |
|
| Author: | JeepinMaxx [ Sun Apr 13, 2008 7:14 pm ] |
| Post subject: | |
Jeepjeepster wrote: Looks nice.
Be careful with that hitch. Since it doesnt use all 6 mounting points I would tow anything close to 5k with it. Thanks for the advice - mostly plan on it as a recovery point for now. If/when I ever buy a camper I'll get a bigger hitch! Also only had grade 8.8 bolts available locally - I need to replace them some 10.9's |
|
| Author: | jsc7002 [ Sun Apr 13, 2008 11:23 pm ] |
| Post subject: | |
JeepinMaxx wrote: Jeepjeepster wrote: Looks nice. Be careful with that hitch. Since it doesnt use all 6 mounting points I would tow anything close to 5k with it. Thanks for the advice - mostly plan on it as a recovery point for now. If/when I ever buy a camper I'll get a bigger hitch! Also only had grade 8.8 bolts available locally - I need to replace them some 10.9's thats what i noticed! |
|
| Author: | BeepBeepJeepJeep [ Mon Apr 14, 2008 9:05 pm ] |
| Post subject: | |
That skid plate is huge |
|
| Author: | JeepinMaxx [ Mon Apr 14, 2008 10:58 pm ] |
| Post subject: | |
BeepBeepJeepJeep wrote: That skid plate is huge
It just fits around the tank / not too much ground clearance loss |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|