to install these... does the square end go to the front or the back on the frame rails?? i know that they are left and right side depepndent and I have the instructions and the template and bits... but I cant tell left from right... on the bars...

_________________
02 Kj 4x4 3" lift, 255/70/16 wildcat EXTs, Rock krawler wheels, Custom sound and video setup inside, magnaflow cat back exhaust, high flow cat, AEM CAI....... much much more to come in the very near future...

Yes, the square one goes in front. Happy drilling!

Keep lots of oil on that drill bit.

_________________
Slightly modified Lt. Khaki 3.7 2004 LTD 4X4. Purchased new 8/6/03.
What I don't have....A Mag light mounted to my seat.
Original Old L.O.S.T. #000354

Nick's Pics & Mods click here: http://www.cardomain.com/ride/531173
http://www.survivaltopics.com/forums/

Just tap the trigger and let go, keep doing this and you'll get fairly quick results from even the cheapest of hand drills. Tapping oil is the best lube I've found for low-speed drilling.

_________________
Ron


"There are few problems in life the liberal application of duct tape can't solve."