Why is the frankenlift better than my ome hd springs and rancho struts? Also when my tire drops into a small crack in the road it kind of clunks? I know ur suppose to expect noises right after the lift, is this one? Also I have bent right front knuckle, is that somethig I can replace myself? And I will certaintly need new alignment after that, or should I just have the mechanic whose doing the alignment do it? Wheel spacers, if I put them in the back only, will I have issues?

Thanks,
Andrew

_________________
'02 Liberty Limited 4x4
-Selec Trac
-MTR's 245/75-16
-Rock Lizard Super Skink Sliders(custom)
-Engine skid, Skidrow Transmission skid
-4" Lift - JBA 4.5 Gen A-arms
Installed@165,920k
Pilot lights on cowl
Engine replacement at 175k

not sure why the franky is better other than it comes assembled, the clunk you hear may be your A arm/balljoint contacting the side of the strut/spring assembly, and as for the spacers i dont think that would hurt any, it may look a bit off but nothing detrimental. others may chime in if i am wrong

_________________
'06 Renegade Jeep Green in color
Frankenlift with heavier rate springs for bumper/winch applications
ARB, Warn Winch, full set of factory skids, JBA gen 4.5 A-Arms, LT245/75 R16 Michelin LTX AT2
Arizona Pinstriping, and desert dust custom paint overlay

I actually ran my Lib with only the spacers in the back for a few weeks or so out of sheer laziness before I got off my booty and did the necessary trimming in the front wheel wells to prevent the rubbing. Didn't cause any issues, and suprisingly enough you don't really notice the difference looking at the truck unless head on.

_________________
-------------------------------------------------------
http://www.cardomain.com/ride/2434197
2002 Liberty Renegade
-OME 927-Rancho RSX 17505-3 Ring Clevis-JBA UCA-Teraflex Bump Stop
-JBA-LIB25R Rear Coil-2 Upper/Lower Iso-Skyjacker H7088 Shocks-3 Hockey Puck Bump Stops
-Powerslot Rotors-Moab Rims-BFG TA/KO 265-75-R16
-ARB Bumper-Rock Rails
-Super 44 Exhaust
+ Some More Crap

I noticed that the front wheels wanted to push when turning / understeer when I just had spacers in the rear

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632