Anyone know off the top of the head what size washers i need to pick up to squeeze in between the rear shock mounts and the bushings? The girlfriends rear shocks have a little play in them and vibrate when driving. The rusty's kit came with washers and i put one on each set, but i guess i need more.

_________________
"You can go fast...I can go anywhere."

i really dont see why you should have to if you installed the ones that came with them. but h/o ill go look and see if i cant tell you the size.

Same thing i thought, but after doing some looking around online, apparently its a common hiccup to have aftermarket shocks vibrate a tad, especially Rusty's shocks.

_________________
"You can go fast...I can go anywhere."

wells here what i came up with. i went outsidea nd took a pic. the red arrow is the washer that came with the kit. the blue arrow is pointing to where you might want to put the next one. hope this helps.

Oh, thanks for the pic, but i know where to put it. I just dont know what size. short of me pulling the bolt out and bringing that with me to home depot, i need the size to save me some gas money.

_________________
"You can go fast...I can go anywhere."

heres what i found from google
http://www.boltdepot.com/Fastener-Infor ... ashers.pdf

its a washer size chart, i think the size that you're looking for is the SAE 9/16

Good Lord just go in and buy some washers , anyone can eye ball what size you need without removing a bolt, easy to do. They have what they call fender washers that work well as well, big flat washers used them on some I have helped install

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited