wells here what i came up with. i went outsidea nd took a pic. the red arrow is the washer that came with the kit. the blue arrow is pointing to where you might want to put the next one. hope this helps.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rear Rustys shocks vibrating http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=33652 |
Page 1 of 1 |
| Author: | Shortbus04 [ Thu Jun 26, 2008 9:19 am ] |
| Post subject: | Rear Rustys shocks vibrating |
Anyone know off the top of the head what size washers i need to pick up to squeeze in between the rear shock mounts and the bushings? The girlfriends rear shocks have a little play in them and vibrate when driving. The rusty's kit came with washers and i put one on each set, but i guess i need more. |
|
| Author: | rangerd77 [ Thu Jun 26, 2008 9:26 am ] |
| Post subject: | |
i really dont see why you should have to if you installed the ones that came with them. but h/o ill go look and see if i cant tell you the size. |
|
| Author: | Shortbus04 [ Thu Jun 26, 2008 9:46 am ] |
| Post subject: | |
Same thing i thought, but after doing some looking around online, apparently its a common hiccup to have aftermarket shocks vibrate a tad, especially Rusty's shocks. |
|
| Author: | rangerd77 [ Thu Jun 26, 2008 9:50 am ] |
| Post subject: | |
wells here what i came up with. i went outsidea nd took a pic. the red arrow is the washer that came with the kit. the blue arrow is pointing to where you might want to put the next one. hope this helps.
|
|
| Author: | Shortbus04 [ Thu Jun 26, 2008 10:45 am ] |
| Post subject: | |
Oh, thanks for the pic, but i know where to put it. I just dont know what size. short of me pulling the bolt out and bringing that with me to home depot, i need the size to save me some gas money. 
|
|
| Author: | rangerd77 [ Thu Jun 26, 2008 10:58 am ] |
| Post subject: | |
heres what i found from google http://www.boltdepot.com/Fastener-Infor ... ashers.pdf its a washer size chart, i think the size that you're looking for is the SAE 9/16 |
|
| Author: | tommudd [ Thu Jun 26, 2008 12:56 pm ] |
| Post subject: | |
Good Lord just go in and buy some washers , anyone can eye ball what size you need without removing a bolt, easy to do. They have what they call fender washers that work well as well, big flat washers used them on some I have helped install |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|