I'm installing something that needs power only when ignition on. Can anyone make a recomendation on what/where I could tap into fairly easy? I pulled the fuse box apart today under the hood and couldn't find anything readily available to tap.

I also couldn't find a good spot in the firewall to pass some wires through. Any suggestions before I start drilling and cutting holes? The single harness gromett was REALLY tight and I didn't want to cut into it.

Thanks..

Radio lead

_________________
02 Liberty Limited
Silver Outside & Taupe Inside
Heated Seats, Sunroof & Infinity speakers
USA Spec I-Pod adaptor, Mopar Sub, Garmin GPS
Tow Package, Select-Trac
Rock Rails, Tow Hooks

It depends on the power demand. It'd help if we knew...but if it needs a significant amount of amperage, I'd run the radio ign-hot lead into a relay and run a heavier gage of wire from the battery.

i would run a wire from the battery a put a relay to cut the powerwhen the ignition is not on. this way you can have all the power you need without blowing any fuses from the car

_________________
A fool and his money are soon parted.
Thomas Tusser

Thanks Shocker. This is what I ended up doing! Plenty of power....

There are plastic blanking grommets in the bulkhead one either side,right in corner of firewall near the inner wing that you can pop out and fit a rubber grommet to pass wires from engine bay to cab.

_________________
2004 2.8 crd Limited