yesterday i had my Cruise Control stop working for me. i can get the light to flash every once and a while after pushing it 500 times but even if you do get it on and push set it wont stay on . just wondering if anyone has had any similar problems??

_________________
2008 KK Limited
Stock for now

maybe your clock spring is/has gone bad. just a guess.

_________________
'03 Liberty w/3.7L & 45FRE Tranny
Revetek 2" Lift & JBA Gen 5 A-arms
Maxxis Buckshot XMT Mudders 31x10.5 on Soft 8's
Jet Stage 2 Chip : '07 Air Intake
Relocated IAT Sensor : '05 HVAC Controls
Front Hitch : EVIC from '01 GC : Custom Rock Rails
Transgo Shift Reprogramming Kit
KC Driving Lights & Aux Backup Lights
.......all GONE!

To answer your question, I've not had any issues with my cruise control

_________________
Have fun out there.

2003 Cactus Green Renegade w/ NP231 & NV3550
Al's 4th Gen UCAs
Custom 3.5" Lift
Rear DTT
Spidertraxed 245/75/16 Maxxis Bighorns

I know I'm kinda late, but I just recently bought an 02 KJ and it's cruise didn't work. It bugged the hell outta me, so I started from front to back checking out the system. Turns out right behind my air intake box there is the cruise control diaphram. It has a plastic hose going into a rubber 90 fitting. Or at least it was supposed to. I don't know how someone could have damaged it, but the fitting was torn and the plastic tube that was supposed to be in there was just hanging out in the engine bay. Well I'm still hunting online for a parts manual, but the quick fix was to cut a piece of my wife's little workout tubing, and zip tie that in the fittings place. Cruise works fine now. This may not be your problem but maybe someone else searching for an answer might find this helpful. Good luck with your cruise.