LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

hi-lift base dims
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=38788		 Page 1 of 1
Author:  jerbacher [ Thu Jan 01, 2009 12:01 pm ]
Post subject:  hi-lift base dims
Could anyone tell me the dimensions of the base of hi-lift jack? thanks!
Author:  loganbrumm [ Thu Jan 01, 2009 7:03 pm ]
Post subject: 
do you mean the attached base or the base stand (sold separately)?
Author:  callaway [ Thu Jan 01, 2009 8:31 pm ]
Post subject: 
The metal base on mine is 4.125" x 7.125"
Author:  jerbacher [ Thu Jan 01, 2009 8:46 pm ]
Post subject: 
callaway wrote:
The metal base on mine is 4.125" x 7.125"


Thanks, yeah that's what I was looking for. I'm thinking of getting the hi-lift off road base to use with my stock bottle jack, but need to see if it will fit. I mostly want it to give enough height to the stock jack to actually use it again with the lift. But I don't really want to get a hi-lift for a variety of reasons.
Author:  jeepskate [ Fri Jan 02, 2009 2:28 am ]
Post subject: 
jerbacher wrote:
callaway wrote:
The metal base on mine is 4.125" x 7.125"


Thanks, yeah that's what I was looking for. I'm thinking of getting the hi-lift off road base to use with my stock bottle jack, but need to see if it will fit. I mostly want it to give enough height to the stock jack to actually use it again with the lift. But I don't really want to get a hi-lift for a variety of reasons.


I'll take a look at mine when I get home, but offhand I don't think you'll gain much height. Maybe an inch if that. Plus, stability would be a concern for me. Even the hi-lift doesn't sit very far down in the base. I think you're better off using a block of wood.

EDIT: Well, I was sure wrong. It's almost 3 inches in height that you'd get, assuming the bottle jack fits. But a block of wood is still cheaper.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/