| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Everything I need to install OME springs and Ranchos???? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=38898 |
Page 1 of 1 |
| Author: | BjBnet [ Mon Jan 05, 2009 10:56 am ] |
| Post subject: | Everything I need to install OME springs and Ranchos???? |
I've done alot of research here and from what I understand when putting in HD OME springs and Ranchos all around I need to replace the bumpstops as well(I think Tom mentioned it a few times  ). Anything else I should be doing? I'm replacing stock...I don't think uca is necessary right, unless I go higher?
Also, are there any how-to instructions here on how to do it all? I know about how dangerous the springs can be when replacing them.... Thanks again guys. |
|
| Author: | daspes [ Mon Jan 05, 2009 11:09 am ] |
| Post subject: | |
All the directions are the same as the Frankenlift install article here: http://www.boulderbars.com/images/kj_pr ... rticle.pdf The only additional thing you'll need is a strut compressor for the springs. |
|
| Author: | DryBones [ Mon Jan 05, 2009 11:54 am ] |
| Post subject: | |
thanks or the link. going to be doing a complet OME swap in the near future too! I think I will have a local shop rebuild the fronts for me though. |
|
| Author: | BjBnet [ Mon Jan 05, 2009 12:10 pm ] |
| Post subject: | |
Thanks Mike, much appreciated |
|
| Author: | jsc7002 [ Mon Jan 05, 2009 3:00 pm ] |
| Post subject: | |
sounds like you've just about got it covered, just read up on all of the lift installs from here and jeepkj they will help you out a lot! and don't be afraid to ask questions while you are installing it, I had too |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|