ohv_kj wrote:
i know many ppl have ask...what lockers will fit my 8.25...the reason i asked is i went to go install a power trax last night and two problems happened...one the ring gear was to big and two the axle shafts seemed to be too long we couldn't slide the center pin in...the driver side axle we were able to move out of the way but, the passenger was tight after we put the c-clip in...any ideas???
checked the same part numbers were showed for a xj and liberty...
I'm just guessing that perhaps you didn't follow exact installation procedure and over looked something on one of the procedures.
Try pulling it back out and start over from square one and follow each step of procedure exactly as stated in the installation guide.
Before putting in the C-clip on the driverside the directions state to check the gap between the drivers using the check block. The narrow side should fit between the drivers, but the wide side should not. If the wide side fits you you should stop and call support at 864-843-9231, there may be a problem with your differential case.
_________________
Slightly modified Lt. Khaki 3.7 2004 LTD 4X4. Purchased new 8/6/03.
What I don't have....A Mag light mounted to my seat.
Original Old L.O.S.T. #000354
Nick's Pics & Mods click here:
http://www.cardomain.com/ride/531173http://www.survivaltopics.com/forums/