LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

P0138 and check engine light
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=42196
Page 1 of 1

Author:  stevemcc [ Mon Apr 13, 2009 1:18 am ]
Post subject:  P0138 and check engine light

Had a check engine light today - pulled the codes with the on off on off etc and got a P0138. Did some digging here and went for a dig under the KJ. All seemed ok, once I'd got the mud cleaned off. Put it back together and started up again - no engine light, but the code is still there.

So my question is - if the lights off is all now good, or does the fact that the code is still there mean there is still a problem?

I've done just over 45,000K's and am just overdue for a service but that wouldn't be the cause would it?

Author:  ATXKJ [ Mon Apr 13, 2009 3:11 am ]
Post subject: 

once you fix a problem it takes 3 engine cycles to clear a CEL by itself -

an engine cycle is start from a low temp warm to operating just off/on doesn't work.

but most of the code readers will clear code immediately to determine if you fixed the problem.

(also dependent on your code reader - you may be able to read old codes i.e. the Chrysler ones can read back a fairly long history even after you cleared it)

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/