just talked to Jason, not sure if I was any help at all but tried
just thought I would post so that everyone knew that someone was trying to help him through his "first" lift 
Next lift will go easier
Tom
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| urgent lift help needed! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=42348 |
Page 1 of 1 |
| Author: | DryBones [ Fri Apr 17, 2009 5:38 pm ] |
| Post subject: | urgent lift help needed! |
Help! I can't get the upper ball joint nuts to go back on! I get them threaded on about 3 turns and they won't budge, either nut on either side, same problem. What am I missing? |
|
| Author: | tommudd [ Fri Apr 17, 2009 5:50 pm ] |
| Post subject: | |
just talked to Jason, not sure if I was any help at all but tried just thought I would post so that everyone knew that someone was trying to help him through his "first" lift
Next lift will go easier
Tom |
|
| Author: | Pablo [ Fri Apr 17, 2009 5:53 pm ] |
| Post subject: | |
Stock or Al's? If Al's are you referring to the ball joint inside it or the whole assembly? Did you take the weight off the lower control arm/ball joint by jacking it up or propping it up so it is not pulling down on the threads while you are trying to tighten the nut on the upper ball joint stud? The upper ball joint stud should be free to slide all the way through the riser of the lower control arm-- so that the control arms sit fairly flush together with plenty of stud threads exposed to thread the nut back onto. |
|
| Author: | DryBones [ Fri Apr 17, 2009 6:30 pm ] |
| Post subject: | |
done with Tom's help. You definitely need to pry that upper arm down into the knuckle and keep some good tension on it to allow you to tighten the nut. THANKS TOM! I OWE YOU A COLD ONE! 
BTW, if the wife likes this when I am done we may do her 02 as well. possibly just light or medium OME's just to get her original height back and maybe a bit more. |
|
| Author: | tommudd [ Fri Apr 17, 2009 6:38 pm ] |
| Post subject: | |
Speaking of which, a cold one would taste REAL good about right now....
heading for the fridge
|
|
| Author: | JeepinJarhead03 [ Fri Apr 17, 2009 6:55 pm ] |
| Post subject: | |
should head for my fridge tom, thats where the Saki and Soju is 
|
|
| Author: | tomsjeep [ Fri Apr 17, 2009 7:17 pm ] |
| Post subject: | |
JeepinJarhead03 wrote: should head for my fridge tom, thats where the Saki and Soju is
Best service I get in stateside Korean restaurants is to order Soju. Usual response is "how you know Soju?" and then I get showered with "extra" dishes. I have to say, this site is such a valuable resource... since owning one of these "odd" Jeeps (KJs) leaves one out in the cold on most Jeep sites. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|