| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| OEM CRD Rear Spring Rate http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=43523 |
Page 1 of 1 |
| Author: | long_tall_texan [ Mon May 25, 2009 7:34 pm ] |
| Post subject: | OEM CRD Rear Spring Rate |
I have seen all of the other spring rates listed. Are the Rear springs on the CRD the same springs as the Rear on the gassers? I know stock gasser fronts are 310 lb springs. Are the rear stock springs also 310? |
|
| Author: | Cali KJ [ Mon May 25, 2009 7:54 pm ] |
| Post subject: | Re: OEM CRD Rear Spring Rate |
long_tall_texan wrote: I have seen all of the other spring rates listed. Are the Rear springs on the CRD the same springs as the Rear on the gassers? I know stock gasser fronts are 310 lb springs. Are the rear stock springs also 310?
LTT I've been down that road |
|
| Author: | jeepkj02 [ Mon May 25, 2009 9:09 pm ] |
| Post subject: | |
I would think the rear would have a lower spring rate, because there is not as much weight. |
|
| Author: | tjkj2002 [ Mon May 25, 2009 9:23 pm ] |
| Post subject: | |
I believe the rear OME 948's(HD coils) is about 200lbs spring rate. |
|
| Author: | Cali KJ [ Mon May 25, 2009 10:58 pm ] |
| Post subject: | |
jeepkj02 wrote: I would think the rear would have a lower spring rate, because there is not as much weight.
Sorry for any confusion!As far as the spring rate? Not sure of the actual rate. CRD rear coils are the same as the gassers. No difference. |
|
| Author: | Cobalt-60 [ Mon May 25, 2009 11:12 pm ] |
| Post subject: | |
Rear OEM KJ gasser coils only rate at 150 lbs. I believe. |
|
| Author: | long_tall_texan [ Mon May 25, 2009 11:29 pm ] |
| Post subject: | |
Cobolt-60 wrote: Rear OEM KJ gasser coils only rate at 150 lbs. I believe.
That makes sense. If OME HD rear springs are 200, 150 sounds about right for the OEM. I wasn't so much concerned about the actual spring rate. I was just curious if the CRD had a heavier rear spring. Didn't think they would be different. But thought I would ask to see. Thanks for all the input! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|