I have the HD's on a completely stock KJ and they're great. Not harsh at all.
I also have stock size General Grabbers and they look right at home.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| OME Springs- Heavy or Medium? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=43619 |
Page 1 of 2 |
| Author: | JeepBumm68 [ Thu May 28, 2009 12:27 pm ] |
| Post subject: | |
Well really it all depends on if you want to run front and rear bumpers in the future. OME HD's will make for stiff ride without bumpers and added weight. But, it well help if you plan on adding bumpers. |
|
| Author: | pssbarry [ Thu May 28, 2009 12:30 pm ] |
| Post subject: | OME Springs- Heavy or Medium? |
I am going to be ordering OME springs tomorrow and I am torn between the medium and heavy. I am not going for maximum lift just want to replace the worn originals and get back some height lost by age. These will be installed with new Ranchos as well. I have 245/70 tires and dont want them to look too small once the new springs are on. I know it has been debated and most have gone with the heavy but wanted to get eveybodys opinion for both to help me decide. Thanks |
|
| Author: | pssbarry [ Thu May 28, 2009 12:36 pm ] |
| Post subject: | |
I meant to mention that in the original post but no future plans for aftermarket bumbers. |
|
| Author: | tommudd [ Thu May 28, 2009 12:39 pm ] |
| Post subject: | |
If....you are never going to have a aftermarket front bumper then you could do mediums, with that said I have installed OME HDs up front on several now with the stock front bumpers and they like them. Look at all the people who have Frankenlifts and no aftermarket front bumpers, those are all Heavy Dutys as well. Without doing a clevis and other things you will only raise about 2 maybe 2.25 over stock anyways |
|
| Author: | jsc7002 [ Thu May 28, 2009 1:20 pm ] |
| Post subject: | |
I would go HD whether you were planning on bumper or not |
|
| Author: | Drassis [ Thu May 28, 2009 2:20 pm ] |
| Post subject: | |
Yup Hd's especially after you get plenty of miles on them they will hold up longer |
|
| Author: | pssbarry [ Thu May 28, 2009 2:24 pm ] |
| Post subject: | |
I guess my thinking is the mediums will sag quicker but the heavys may ride to stiff. Will there be much of a differnce in lift height between the two? |
|
| Author: | jamangus [ Thu May 28, 2009 2:25 pm ] |
| Post subject: | |
HD frankenlift on my 07 rode like crap before adding the weight of a winch & mount. |
|
| Author: | djui5 [ Thu May 28, 2009 3:54 pm ] |
| Post subject: | |
jsc7002 wrote: I would go HD whether you were planning on bumper or not
Yep. I've got HD springs in the front of mine with factory plastic bumper and it rides just fine. I got MD in the rear and although it rides ok, I wish I would have waited for the HD springs. |
|
| Author: | ShafferNY [ Thu May 28, 2009 4:15 pm ] |
| Post subject: | |
I have the HD's on a completely stock KJ and they're great. Not harsh at all. I also have stock size General Grabbers and they look right at home.
|
|
| Author: | Cobalt-60 [ Thu May 28, 2009 4:42 pm ] |
| Post subject: | |
Do your self a favor and go with the OME HDs now. Once you start adding weight (and no matter what you say now, you will) the front will start to sag. So, I may not have an ARB front bumper, but I do have the following which all add some weight to the front: Front Skid Plate Engine/Transmission Skid Plate Transfer Case Skid Plate Rock Rails Front Differential Collar Front Receiver Hitch All add sprung weight to the vehicle. Even the Hella 500s that I still have to add to the front will add a little bit more weight. Now put my 250 lbs. in the driver's seat,... and you get the idea... 
|
|
| Author: | pssbarry [ Thu May 28, 2009 4:46 pm ] |
| Post subject: | |
I guess if I go with the HD's and the ride is too stiff I can just eat more and put some weight on. 
|
|
| Author: | Jeepjeepster [ Thu May 28, 2009 4:52 pm ] |
| Post subject: | |
I had mediums on the front and it did not lift it near as high as the OME HD's on the rear. Rustys coils brought it up level with the rear. |
|
| Author: | djui5 [ Thu May 28, 2009 5:14 pm ] |
| Post subject: | |
pssbarry wrote: I guess if I go with the HD's and the ride is too stiff I can just eat more and put some weight on.
Or it would be a good excuse to buy an ARB bumper and winch
|
|
| Author: | Drassis [ Thu May 28, 2009 6:18 pm ] |
| Post subject: | |
djui5 wrote: pssbarry wrote: I guess if I go with the HD's and the ride is too stiff I can just eat more and put some weight on. Or it would be a good excuse to buy an ARB bumper and winch it will ride stiff for the first month or two but after that it will feel just right |
|
| Author: | pssbarry [ Thu May 28, 2009 6:56 pm ] |
| Post subject: | |
You'all just about have me talked into the HD's. |
|
| Author: | oddball [ Thu May 28, 2009 7:51 pm ] |
| Post subject: | |
I'm going with OME HD's front & rear. Mind you my bumpers are stock and regardless of the fact I don't plan to replace my bumpers, I also believe never say never. |
|
| Author: | JeepinJarhead03 [ Thu May 28, 2009 8:18 pm ] |
| Post subject: | |
where exactly are you fellas getting HD's for the REAR .. ? |
|
| Author: | JeepinJarhead03 [ Thu May 28, 2009 8:22 pm ] |
| Post subject: | |
nevermind i'm a friggin idiot, the 948's are the 'hd's for the rear (...facepalm...) |
|
| Author: | tommudd [ Thu May 28, 2009 8:35 pm ] |
| Post subject: | |
JeepinJarhead03 wrote: nevermind i'm a friggin idiot, the 948's are the 'hd's for the rear
(...facepalm...) glad I didn't have to point that out to you, you know what an idiot you are. Knowing that you are is the first step to recovery
|
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|