The Moog K6292 Ball Joint is the replacement joint used on aftermarket upper control arms on the KJ. I require MOOG specs on the pin dimensions of the ball joint. Assistance with the spec's will be appreciated.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Required Moog K 6292 balljoint pin spec http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=43706 |
Page 1 of 1 |
| Author: | Selwyn [ Sun May 31, 2009 12:43 am ] |
| Post subject: | Required Moog K 6292 balljoint pin spec |
| The Moog K6292 Ball Joint is the replacement joint used on aftermarket upper control arms on the KJ. I require MOOG specs on the pin dimensions of the ball joint. Assistance with the spec's will be appreciated.
|
|
| Author: | djui5 [ Sun May 31, 2009 3:31 am ] |
| Post subject: | |
U sure? Everywhere I looked it was for GM trucks. It will fit in the JeepinByAl A-Arms though. Anyway, might wanna ask the manufacturer here: http://www.federal-mogul.com/en/ContactUs/ |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|