LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

lockers: ARB in Rear, DTT in Front set-up
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=43711		 Page 1 of 1
Author:  luckys13 [ Sun May 31, 2009 7:53 am ]
Post subject:  lockers: ARB in Rear, DTT in Front set-up
Due to cost, I wonder if anyone is running something like a ARB in the rear and a DTT in the front. I have read a few posts in which everyone seems very happy with the DTT in the front.

Is a set up like this possible? Would there be any issues in having this type of setup? I guess I could just save a little more for the full ARB but thought maybe just the rear would be good. Any suggestions?
Author:  tjkj2002 [ Sun May 31, 2009 8:06 am ]
Post subject: 
That setup works awesome,I ran that setup for 3 years.
Author:  LIV42DY [ Sun May 31, 2009 5:48 pm ]
Post subject: 
True it is a great set up, but due to the nature of the aluminun case in the front, I would run DTL in the rear and ARB in the front.
Author:  2006 KJ [ Sun May 31, 2009 6:02 pm ]
Post subject: 
if your going to use an ARB in the rear.. i'd just wait and pinch penny's till you could get one for the front as well since you'll already have the compressor all installed/plumbed. ARB's front and rear is the best possible set up for our KJ's.
Author:  djui5 [ Sun May 31, 2009 6:14 pm ]
Post subject:  Re: lockers: ARB in Rear, DTT in Front set-up
luckys13 wrote:
Any suggestions?


Run the OX locker in both axles. It'll cost about the same and they are selectable also. Plus you get diff covers :D
Author:  nosnorb_808 [ Sun May 31, 2009 6:53 pm ]
Post subject: 
I never knew that there was an Ox locker for the D30A. :?
Author:  tjkj2002 [ Sun May 31, 2009 7:41 pm ]
Post subject: 
nosnorb_808 wrote:
I never knew that there was an Ox locker for the D30A. :?
Because it will not work,not that it will not fit but the needed diff cover will not fit due to the D30A mounts would interfere.

Quote:
if your going to use an ARB in the rear.. i'd just wait and pinch penny's till you could get one for the front as well since you'll already have the compressor all installed/plumbed. ARB's front and rear is the best possible set up for our KJ's.
I'm a big fan of ARB's but F/R ARB's in a KJ is not the best since you are limited to when you can actually engage that front ARB and still turn unlike the DTT which will automatically compensate.I believe the DTT in the front and ARB is the best setup for a KJ,I know that setup has worked better for me then F/R ARB's as in I could go more places with ease then a F/R equipped KJ.
Author:  djui5 [ Sun May 31, 2009 7:47 pm ]
Post subject: 
tjkj2002 wrote:
nosnorb_808 wrote:
I never knew that there was an Ox locker for the D30A. :?
Because it will not work,not that it will not fit but the needed diff cover will not fit due to the D30A mounts would interfere.


Oh! Sorry for passing on bad info :) Thanks for the correction.
Author:  tjkj2002 [ Sun May 31, 2009 7:56 pm ]
Post subject: 
djui5 wrote:
tjkj2002 wrote:
nosnorb_808 wrote:
I never knew that there was an Ox locker for the D30A. :?
Because it will not work,not that it will not fit but the needed diff cover will not fit due to the D30A mounts would interfere.


Oh! Sorry for passing on bad info :) Thanks for the correction.
Oh and they also do not make a OX locker for the 8.25 either so basically OX lockers are out for a KJ unless you change both F/R axles.
Author:  djui5 [ Mon Jun 01, 2009 1:31 am ]
Post subject: 
tjkj2002 wrote:
Oh and they also do not make a OX locker for the 8.25 either so basically OX lockers are out for a KJ unless you change both F/R axles.


Yep, correct there too. I was riding the fail bus on that one :D
Author:  luckys13 [ Mon Jun 01, 2009 8:26 am ]
Post subject: 
Thanks for the suggestions. Its still a toss up I guess between full ARB and DTT..... I guess I will see how much more money is left in the piggy bank and make the decision..
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/