| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| cv shafts http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=44189 |
Page 1 of 1 |
| Author: | sidewayskj [ Mon Jun 15, 2009 1:08 pm ] |
| Post subject: | cv shafts |
Well passanger cv side is making a good clunk when turning slow and I think I hear the drivers side doing it. Then passenger side clip is loose so before someone gets on the clevis bushing on control arm thing I know the passenger cv is gone. I was wondering if I should change both cv's at the same time or just do the passenger one. The other one is if I buy a whole complete unit is it going to be slide in ready on the passenger side or do I need to order the clips for the passenger side as well as a whole cv unit. Thanks again just trying to get my jeep as good as new. |
|
| Author: | sidewayskj [ Tue Jun 16, 2009 1:45 am ] |
| Post subject: | |
nevermind about his post need to get a cv half shaft looked into it more don't need a inner shaft and clip |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|