| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| More Height http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=44352 |
Page 1 of 1 |
| Author: | WarriorMP31B [ Sat Jun 20, 2009 9:07 am ] |
| Post subject: | More Height |
So it's been over five weeks without my KJ (stupid deployment |
|
| Author: | 501 [ Sat Jun 20, 2009 10:11 am ] |
| Post subject: | |
You can add a clevis lift in the front and a couple of ISO pads in the rear. |
|
| Author: | Quicksilversurf917 [ Sat Jun 20, 2009 10:16 am ] |
| Post subject: | |
Or there is the cradel drop about 1/2in in the front |
|
| Author: | durangotang [ Sat Jun 20, 2009 11:11 am ] |
| Post subject: | |
Cradle drop doesn't add lift. |
|
| Author: | Hood297 [ Sat Jun 20, 2009 11:48 am ] |
| Post subject: | |
But It will give you more clearance for bigger tires thus= more lift. and happier CV angles |
|
| Author: | WarriorMP31B [ Sat Jun 20, 2009 11:54 am ] |
| Post subject: | |
Thanks for the suggestions! I'll definitely have to explore these ideas when I get back to get some bigger tires. |
|
| Author: | JL Rockies [ Sat Jun 20, 2009 2:29 pm ] |
| Post subject: | |
But the biggest tire the front diff can handle can already fit without a cradle drop. |
|
| Author: | scout [ Sat Jun 20, 2009 3:45 pm ] |
| Post subject: | Re: More Height |
WarriorMP31B wrote: So it's been over five weeks without my KJ (stupid deployment
Where are you at? |
|
| Author: | durangotang [ Sat Jun 20, 2009 5:03 pm ] |
| Post subject: | |
Hood297 wrote: But It will give you more clearance for bigger tires thus= more lift. and happier CV angles
Our UCA's are not attached to the cradle so the entire suspension assembly does not drop as it does on most other rigs. The cradle drop has minimal effect other than chagning the angles between the upper and lower control arms (not to mention making your balljoints unhappy). Not a productive mod unless you extend the knuckles and keep the factory geometry. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|