JBA CV Axle Shafts

scrappy04 · **Joined:** Mon Sep 17, 2007 9:25 pm **Posts:** 19

Has anyone tried the JBA CV Axle shafts? My CV angles are pretty bad since I don't have enough weight in the front for the HD springs and the JBAs are a lot less expensive the J.E. Reels so I would much rather go that route... since I'm broke.

LIV42DY · **Posted:** Tue Aug 04, 2009 10:41 pm

I have the same with no weight in the front and no issues as of yet. Still stock shafts. How bad is the angle? Post a picture, lets take a look

vman · **Posted:** Thu Aug 06, 2009 4:22 pm

I'll let you know. Just ordered both sides. Recently replaced my old OTT lift w/ Frenakenlift 1 and JBA arms. Developed an issue w the passenger side CV and tried replacing w/ stock and it made more noise than before. Hoping the new CV shafts solve the problem.

vman · **Posted:** Wed Aug 19, 2009 1:25 pm

OK they're on and it eliminated the noise. Only time will tell how good these are. Considering I got 95K on my stock CVs and all of those miles w/ a lift, I would expect about the same or better.

kjsport05 · **Posted:** Thu Aug 20, 2009 9:13 am

mine should be installed today ... along with the DTT up front

time to go break more stuff lol

scrappy04 · **Joined:** Mon Sep 17, 2007 9:25 pm **Posts:** 19

When were your old cv joints making noise? I think my problem is the cv joints but I don't know?

kjsport05 · **Posted:** Fri Aug 21, 2009 2:47 am

mine started out making noise when doing anywhere from 45 to 60mph and it sounded like something was smacking underneath everytime the cvs made a revolution. it was extremely annoying and sounded like something seriously was going to shatter.

JBA CV Axle Shafts

Who is online