| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Water temp http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=45546 |
Page 1 of 1 |
| Author: | rt_power [ Mon Aug 03, 2009 10:27 am ] |
| Post subject: | Water temp |
what would you guys suggest as a normal operating water temp for the KJ?? I recently installed a gauge pod and i am seeing temps any where from 210-240F, is this normal??. The other thing i maybe not trust is the gauge pod gauge. It seems that when ever i add any electrical load to the (head lights,fogs,light bar, HVAC fan etc) the gauge seems to spike by say 10-15 degrees. not sure what would cause this but anyone's insight would be great |
|
| Author: | Jeepjeepster [ Mon Aug 03, 2009 5:49 pm ] |
| Post subject: | |
Mine runs around 193-195F when running down the road(55mph+). At idle Ive seen it as high as 220F or so unless I have the A/C on, then it stays at 195F since the fan runs all the time. If you have the mechanical fan it may not get as high as one with just the electric fan. Thats one reason I dont like having just an electric fan, it only kicks on at a certain temp. A mechanical fan is always pulling a small amount of air even if its not fully engaged. |
|
| Author: | tjkj2002 [ Mon Aug 03, 2009 10:32 pm ] |
| Post subject: | |
The t-stat in your KJ doesn't fully open till 218 degrees,with that being said the normal operating temp is from about 195-235 degrees before you start getting into danger.The electric fan should not even come on till about 215-220 degrees. |
|
| Author: | tommudd [ Mon Aug 03, 2009 10:42 pm ] |
| Post subject: | |
according to my scan guage mine seems to run about 198 to 220 or so in most driving conditions |
|
| Author: | rt_power [ Mon Aug 03, 2009 10:48 pm ] |
| Post subject: | |
ok that temps about right then. just thought it would be in the 180-200f range. i guess it must be the gauge itself that for whatever reason seams to spike when i turn on the lights etc. Guess ill have to trace out that problem |
|
| Author: | tjkj2002 [ Mon Aug 03, 2009 10:52 pm ] |
| Post subject: | |
rt_power wrote: ok that temps about right then. just thought it would be in the 180-200f range. i guess it must be the gauge itself that for whatever reason seams to spike when i turn on the lights etc. Guess ill have to trace out that problem Electronic gauge or mechanical gauge? Electric gauges are never even close.
|
|
| Author: | Albert [ Tue Aug 04, 2009 10:34 am ] |
| Post subject: | |
My Scangauge reads 198-205 mostly. Still running the original t-stat. |
|
| Author: | tjkoen01 [ Tue Aug 04, 2009 12:57 pm ] |
| Post subject: | |
tjkj2002 wrote: rt_power wrote: ok that temps about right then. just thought it would be in the 180-200f range. i guess it must be the gauge itself that for whatever reason seams to spike when i turn on the lights etc. Guess ill have to trace out that problem Electronic gauge or mechanical gauge? Electric gauges are never even close.electrical gages require a good steady voltage to get a good steady reading....you might want to get your battery checked, could be getting weak what kind of gages did you buy? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|