LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

JBA CV Axle Shafts
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=45580		 Page 1 of 1
Author:  scrappy04 [ Tue Aug 04, 2009 8:54 am ]
Post subject:  JBA CV Axle Shafts
Has anyone tried the JBA CV Axle shafts? My CV angles are pretty bad since I don't have enough weight in the front for the HD springs and the JBAs are a lot less expensive the J.E. Reels so I would much rather go that route... since I'm broke.
Author:  LIV42DY [ Tue Aug 04, 2009 10:41 pm ]
Post subject: 
I have the same with no weight in the front and no issues as of yet. Still stock shafts. How bad is the angle? Post a picture, lets take a look
Author:  vman [ Thu Aug 06, 2009 4:22 pm ]
Post subject: 
I'll let you know. Just ordered both sides. Recently replaced my old OTT lift w/ Frenakenlift 1 and JBA arms. Developed an issue w the passenger side CV and tried replacing w/ stock and it made more noise than before. Hoping the new CV shafts solve the problem.
Author:  vman [ Wed Aug 19, 2009 1:25 pm ]
Post subject: 
OK they're on and it eliminated the noise. Only time will tell how good these are. Considering I got 95K on my stock CVs and all of those miles w/ a lift, I would expect about the same or better.
Author:  kjsport05 [ Thu Aug 20, 2009 9:13 am ]
Post subject: 
mine should be installed today ... along with the DTT up front :D time to go break more stuff lol
Author:  scrappy04 [ Thu Aug 20, 2009 4:15 pm ]
Post subject: 
When were your old cv joints making noise? I think my problem is the cv joints but I don't know?
Author:  kjsport05 [ Fri Aug 21, 2009 2:47 am ]
Post subject: 
mine started out making noise when doing anywhere from 45 to 60mph and it sounded like something was smacking underneath everytime the cvs made a revolution. it was extremely annoying and sounded like something seriously was going to shatter.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/