| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| A clunking sound http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=48029 |
Page 1 of 1 |
| Author: | ZERO6 [ Sun Nov 22, 2009 6:40 pm ] |
| Post subject: | A clunking sound |
Have replaced the rear upper control arm bushings and ball joint. My clunking noise seems to be half of what it was. Would the trailing arm bushings contribute to this clunking noise? Seems to happen when off and on the throttle at regular daily driving.. Any ideas....? |
|
| Author: | JNJ-Z [ Sun Nov 22, 2009 8:10 pm ] |
| Post subject: | |
check the rear drive shaft-(u-joints) |
|
| Author: | Neatus [ Mon Nov 23, 2009 11:20 am ] |
| Post subject: | |
Also check to make sure your upper shock mounts are tight. |
|
| Author: | jeepzilla [ Mon Nov 23, 2009 1:58 pm ] |
| Post subject: | |
sounds like the same problem I had recently. I agree it might be the rear u-joints, that's what mine was... |
|
| Author: | M&P40 [ Mon Nov 23, 2009 7:25 pm ] |
| Post subject: | |
my clunking noise happens where the A-arm comes out of the unibody, the bottom of the arm contacts the bottom of the cut out where the arm transitions from inside the engine compartment to inside the wheel well and created a clunk |
|
| Author: | ZERO6 [ Wed Nov 25, 2009 5:46 pm ] |
| Post subject: | |
Ok thanks guy's, will check this Saturday. I will let you all know what it was.. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|