Apparenly, I need new front axles as my lift apparently has reuined them. Are there any aftermarket axles with a better angle? My mechanic said that they are worn because they are pitched at such an angle with the lift. When I replace them if there are no aftermarket, will i have the same issue or will it come with time? Thanks in advance!

_________________
16" Moabs, No Slip Powertrax Locker, Detroit TruTrac Front LSD, 2.5+ Full OME Rockfather II lift, Rhino Lined lower body, roof and light bar, MBR Exhaust, Factory GPS, Bull Bar

look http://jeepinbyal.com/cat-Front_Drive_Axle_Components-21.aspx[/code]

_________________
I'm baaaaccckkk...
LOST Member 10
If you can read this you don't need glasses, go Wheel your Jeep!

thanks, but that's stock and way expensive. I can get stock ones for $80.00 a piece, was just seeing if there was an upgrade

_________________
16" Moabs, No Slip Powertrax Locker, Detroit TruTrac Front LSD, 2.5+ Full OME Rockfather II lift, Rhino Lined lower body, roof and light bar, MBR Exhaust, Factory GPS, Bull Bar

He does have a set that have the face machined for lifted Liberty's. It says they will not fail from the Jeep being lifted. So I guess that would be an upgrade. How good they are I don't know.

Terry

_________________
2011 Ford F-150 XLT 4X4

Stock front CV's,as in OEM ones,are from $260-$760 each.Those china made ones from advance auto that are labeled "new" are junk and 90% of the time are the wrong sized shafts for your vehicle,I have run into it many times already.Stick with Remaned axles(not "new" ones),JE Reel, or OEM axles from the dealership.

AMEN !!, I have installed many shaft's in Lifted KJ's lateley and the NEW shafts "SUCK" ! Get some reman shaft's and make sure they have "OEM" end's !!

_________________
96 XJ with a lot of crap !!
04 KJ with some crap!!
15 Forester XT
14 STI Wagon
75 Cutlass "S"