LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Front Axles Aftermarket????
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=48120		 Page 1 of 1
Author:  ridah011 [ Fri Nov 27, 2009 3:18 pm ]
Post subject:  Front Axles Aftermarket????
Apparenly, I need new front axles as my lift apparently has reuined them. Are there any aftermarket axles with a better angle? My mechanic said that they are worn because they are pitched at such an angle with the lift. When I replace them if there are no aftermarket, will i have the same issue or will it come with time? Thanks in advance!
Author:  USAFCOP [ Fri Nov 27, 2009 3:52 pm ]
Post subject: 
look http://jeepinbyal.com/cat-Front_Drive_Axle_Components-21.aspx[/code]
Author:  ridah011 [ Fri Nov 27, 2009 4:52 pm ]
Post subject: 
thanks, but that's stock and way expensive. I can get stock ones for $80.00 a piece, was just seeing if there was an upgrade
Author:  Fulltimer [ Fri Nov 27, 2009 5:23 pm ]
Post subject: 
He does have a set that have the face machined for lifted Liberty's. It says they will not fail from the Jeep being lifted. So I guess that would be an upgrade. How good they are I don't know.

Terry
Author:  tjkj2002 [ Fri Nov 27, 2009 10:07 pm ]
Post subject: 
ridah011 wrote:
thanks, but that's stock and way expensive. I can get stock ones for $80.00 a piece, was just seeing if there was an upgrade
Stock front CV's,as in OEM ones,are from $260-$760 each.Those china made ones from advance auto that are labeled "new" are junk and 90% of the time are the wrong sized shafts for your vehicle,I have run into it many times already.Stick with Remaned axles(not "new" ones),JE Reel, or OEM axles from the dealership.
Author:  1996xj [ Fri Nov 27, 2009 10:12 pm ]
Post subject: 
AMEN !!, I have installed many shaft's in Lifted KJ's lateley and the NEW shafts "SUCK" ! Get some reman shaft's and make sure they have "OEM" end's !!
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/