Rockford Duraboot CV boot ???

1996xj · **Posted:** Sat Jan 02, 2010 7:10 pm

I remember a post about "Rockford Duraboot" a CV boot that was suppose to be tough and hard to tear up. I cannot remember if it was "S-10" boot that would work or some other make, they don't list a liberty in the jeep application section ?? :JEEPIN:

tommudd · **Posted:** Sat Jan 02, 2010 7:55 pm

http://www.rockfordcv.com

Part number 815-21L
for S-10s
This is the boot Al Handy ( JeepinbyAl) was using all of the time
18 bucks each according to their website

I have one in the garage

of course :wink:

1996xj · **Posted:** Sat Jan 02, 2010 9:40 pm

Thank's Jamie and Tom, Chris is going to be needing some inner and outter boot's, the aftermarket shaft's that he has has the soft rubber boot's and with the extreme angle's the inner are getting tore up !! Rev. Mud you might have to show him the LIGHT !!!! :JEEPIN:

03CDKJ · **Posted:** Sat Jan 02, 2010 9:48 pm

I'm just getting a dana 44...... SICK OF IT!

InCommando · **Posted:** Mon Jan 04, 2010 6:40 pm

What D44 are ya using?

Great info on the duraboot.

tommudd · **Posted:** Mon Jan 04, 2010 7:08 pm

InCommando wrote:

What D44 are ya using?

Great info on the duraboot.

I have had that info in my "little book of tricks" from back when I talked to Al (Handy) and he told me what he was using. Then I picked up some parts this summer over East and lo and behold I get a CV rebuilt by Al and also an extra Dura boot :wink:

Rockford Duraboot CV boot ???

Who is online