| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 5 odb codes showed up. help needed http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=49506 |
Page 1 of 1 |
| Author: | sideoutdude16 [ Fri Jan 22, 2010 3:43 am ] |
| Post subject: | 5 odb codes showed up. help needed |
I have a 2005 Jeep Liberty 3.7L. im almost at 50k milestone right now. my wife took the jeep to work today and she stated that when she was pulling up to a light to stop, she felt the engine that is trying to stall then the CEL started blinking. She had to press the gas to keep it running to get to work since it was a block away from where she was. i have the 5 following codes showed up after reading some posts. i would like to know where i could get the parts via online if possible? P0300 Random/Multiple Cylinder Misfire Detected P0335 Crankshaft Position Sensor A Circuit Malfunction P0339 Crankshaft Position Sensor A Circuit Intermittent P0522 Engine Oil Pressure Sensor/Switch Circuit Low Voltage P0839 Four Wheel Drive (4WD) Switch Circuit High ive done my research and wanted to know whats the best fix for those? I want to avoid the dealership if possible with those codes throwing at me. |
|
| Author: | JeepinJarhead03 [ Fri Jan 22, 2010 3:51 am ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
I'm just taking a stab tbh.. but a bad crank sensor can cause the misfire, the almost knocking off/stalling can cause the low oil pressure but add in the 4wd circuit and it more sounds like the ECM going bad? |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 4:33 am ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
Where do u think where i can find the camshaft sensor from? Dealership would charge me more for it so i would like to order online if possible what websites do u recommend? |
|
| Author: | JeepinJarhead03 [ Fri Jan 22, 2010 4:58 am ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
try autozone or advance, i think it's about 30 bucks it's on the front near the top of the drivers side head |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 4:01 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
i called autozone and they have duralast camshaft position sensor, is it any good? thats the only thing they have in stock for the jeep. Im not sure if duralast is an good manufacturer so asking for some tips from you guys? |
|
| Author: | JeepinJarhead03 [ Fri Jan 22, 2010 4:30 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
I personally have never had a problem with duralast EXCEPT their brake pads lol but everything else, electronic and minor mechanical other than brake pads i've R&R'ed and gone on about my business and never had a problem from the part |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 4:32 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
alright ill call and reserve one for me tonight, they have the last one in stock |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 5:41 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
ill keep you guys posted after doing it tonight if it doesnt snow/rain |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 6:59 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
Something's def weird now my cel is gone and there is no codes anymore. What can cause this to happen? |
|
| Author: | ATXKJ [ Fri Jan 22, 2010 9:03 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
3 engine cycles from the last detection will clear CEL Codes are stored in a memory that you need dealer type equipment to read does it still have the problem running? |
|
| Author: | sideoutdude16 [ Fri Jan 22, 2010 9:18 pm ] |
| Post subject: | Re: 5 odb codes showed up. help needed |
i ran the scan and used the ignition. no codes comes up. what gives? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|