That lift was well tested over time and never had any problems at all so yes you'll be fine !
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Longer drive shaft/cut CVs http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=49926 |
Page 1 of 1 |
| Author: | TexasRock [ Fri Feb 05, 2010 11:02 am ] |
| Post subject: | Longer drive shaft/cut CVs |
Are these needed on a lift? Reason I'm asking is I have noticed that the rear axle is moved forward when lifting the KJ. Would a longer DS put it back into factory specs? Also, would cut/machined CVs decrease the stress caused by the increased angles? Thanks! Keith |
|
| Author: | tommudd [ Fri Feb 05, 2010 12:06 pm ] |
| Post subject: | Re: Longer drive shaft/cut CVs |
Driveshaft would not shove the axle back. You would need longer lower control arms , plus then you would also need to move the top of the diff to keep the angles correct. Lots of time and money for really nothing. When you stuff the wheel up into the wheel well its arc allows it to stuff up in anyways Cut CVs would and do help over 4 inches I would say up to that not really needed |
|
| Author: | TexasRock [ Fri Feb 05, 2010 2:23 pm ] |
| Post subject: | Re: Longer drive shaft/cut CVs |
Thank you Reverend Mud! I appreciate it. I think I will be ok with Troys lift without the CVs. |
|
| Author: | tommudd [ Fri Feb 05, 2010 2:44 pm ] |
| Post subject: | Re: Longer drive shaft/cut CVs |
That lift was well tested over time and never had any problems at all so yes you'll be fine !
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|