LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/
steering knuckle http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=50561	Page 1 of 1

---

Author:	yodejt02 [ Fri Feb 26, 2010 6:22 pm ]
Post subject:	steering knuckle
I was just wondering how hard of a job it was to change the ball joint on the steering knuckle by the wheel. It seems that I have some grease leaking from that joint which I take it means the joint has failed. Let me know if I am wrong or what thanks

---

Author:	JeepinJarhead03 [ Fri Feb 26, 2010 6:25 pm ]
Post subject:	Re: steering knuckle
tie rod end, upper control arm ball joint? which?

---

Author:	yodejt02 [ Fri Feb 26, 2010 6:40 pm ]
Post subject:	Re: steering knuckle
I believe its the tie rod end, I believe. Here is a pic

---

Author:	JeepinJarhead03 [ Fri Feb 26, 2010 7:00 pm ]
Post subject:	Re: steering knuckle
bout 40 some dollars ish from JBA or any other supplier the cheeper falcon's are greasable, the moogs aren't kind of a flip flop in that department

---

Author:	yodejt02 [ Fri Feb 26, 2010 8:08 pm ]
Post subject:	Re: steering knuckle
could this wait a week. Money is tight and dont think I could do it this weekend.

---

Author:	tommudd [ Fri Feb 26, 2010 8:32 pm ]
Post subject:	Re: steering knuckle
See if it has any movement to it grab it and try to move it up and down, if none then you will be fine for a while, but with all of the crap on the roads it will work in there and make it get worse faster. You should be good for a while though Get Moog parts I have two in stock in the garage will get you a number after while!

---

Author:	JeepinJarhead03 [ Fri Feb 26, 2010 8:51 pm ]
Post subject:	Re: steering knuckle
ES3535 and ES3536 are the moog TRE's Driver / Pass but they're non-zerk if there's moog greasable tre's i'm sendin the 3535/3536's back to marlin

---

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/