| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transmission Skid Plate for 03 Renny http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=51644 |
Page 1 of 1 |
| Author: | jimymc [ Tue Apr 06, 2010 8:00 pm ] |
| Post subject: | Transmission Skid Plate for 03 Renny |
What is the best/cheapest way to get a tranny skid plate for my 03 Renny? I already have all the rest, but would like to cover that big, vulnerable tranny pan before it finds a can opener.  Not too bad a problem in Florida, but we are headed back out West this Summer and I would like to keep the tranny pan in one piece.
|
|
| Author: | JeepinJarhead03 [ Tue Apr 06, 2010 8:26 pm ] |
| Post subject: | Re: Transmission Skid Plate for 03 Renny |
one of the newer model ie: 05 tranny skids will work, just have to beat part of the upper side of it flat with a big hammer so that it clears the exhaust on the drivers side, and drill a different hole in the skid so that it lines up with pre-existing holes on the trailing side the front side will sandwich just fine between the engine skid and the cross member |
|
| Author: | jimymc [ Tue Apr 06, 2010 9:25 pm ] |
| Post subject: | Re: Transmission Skid Plate for 03 Renny |
JeepinJarhead03 wrote: one of the newer model ie: 05 tranny skids will work, just have to beat part of the upper side of it flat with a big hammer so that it clears the exhaust on the drivers side, and drill a different hole in the skid so that it lines up with pre-existing holes on the trailing side the front side will sandwich just fine between the engine skid and the cross member Do you know if there is a "How To" somewhere on the Lost site? |
|
| Author: | Neatus [ Wed Apr 07, 2010 11:00 am ] |
| Post subject: | Re: Transmission Skid Plate for 03 Renny |
jimymc wrote: JeepinJarhead03 wrote: one of the newer model ie: 05 tranny skids will work, just have to beat part of the upper side of it flat with a big hammer so that it clears the exhaust on the drivers side, and drill a different hole in the skid so that it lines up with pre-existing holes on the trailing side the front side will sandwich just fine between the engine skid and the cross member Do you know if there is a "How To" somewhere on the Lost site? It is actually pretty self explanitory once you have the skid in hand. You will see the spot that you need to beat with the hammer. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|