| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Front Driveshaft specs. question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=52366 |
Page 1 of 1 |
| Author: | mrneen [ Sat May 01, 2010 9:07 pm ] |
| Post subject: | Front Driveshaft specs. question |
Hey everyone.... So i just bought a used front driveshaft for my 2003 jeep liberty... $50 from a local junkyard... howevere it is no good... already broke. so now i am just going to bite the bullet and buy a new one. my question is... what are the specs? length? where can i get one etc. i have looked at NAPA online, and have found 3 different versions for my 2003 sport. 16, 18 or 19 inch long... but i do not know which one i need thanks everyone josh |
|
| Author: | Diggerfreek [ Sat May 01, 2010 11:22 pm ] |
| Post subject: | Re: Front Driveshaft specs. question |
If you measure from the tip of the input flange on the front diff to the tip of the output flange on the t case, that should tell you.. |
|
| Author: | InCommando [ Sun May 02, 2010 8:25 am ] |
| Post subject: | Re: Front Driveshaft specs. question |
Automotive Parts Unlimited, LLC 800-270-5224 or ericautopart@aol.com I think if you know your t-case & tranny combo, you can get the right length, IIRC. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|