Took off the skid plates today to re-paint them prior to the spring wheeling season. I think they got beat last year
The skid was hitting the exhaust and diff in a few places
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Skid plate issues http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=52770 |
Page 1 of 1 |
| Author: | JeepinMaxx [ Sat May 15, 2010 11:26 pm ] |
| Post subject: | Skid plate issues |
Took off the skid plates today to re-paint them prior to the spring wheeling season. I think they got beat last year The skid was hitting the exhaust and diff in a few places
|
|
| Author: | KJ 119 [ Sun May 16, 2010 9:21 am ] |
| Post subject: | Re: Skid plate issues |
Roll over it a few times.It'll be good as new. OK,mabe not good as new,but it'll be straight.
|
|
| Author: | JL Rockies [ Sun May 16, 2010 11:50 am ] |
| Post subject: | Re: Skid plate issues |
Must be MOPAR? |
|
| Author: | InCommando [ Sun May 16, 2010 12:01 pm ] |
| Post subject: | Re: Skid plate issues |
JL Rockies wrote: Must be MOPAR? I hate to burst one of the "JBA sucks because of his beliefs" or " Mopar skids suck" rants you go off on regulalry, but IMHO that does not look look like a Mopar and this is in his sig: Skid Row belly skidplate |
|
| Author: | BVCRD [ Mon May 24, 2010 4:58 pm ] |
| Post subject: | Re: Skid plate issues |
That's not Mopar. Too much metal thickness. |
|
| Author: | Powerman04 [ Mon May 24, 2010 5:01 pm ] |
| Post subject: | Re: Skid plate issues |
BVCRD wrote: That's not Mopar. Too much metal thickness. If he did have Mopar, I'd hate to see his underside if he managed to do that to a Skidrow. 
|
|
| Author: | BVCRD [ Mon May 24, 2010 5:05 pm ] |
| Post subject: | Re: Skid plate issues |
Powerman04 wrote: BVCRD wrote: That's not Mopar. Too much metal thickness. If he did have Mopar, I'd hate to see his underside if he managed to do that to a Skidrow. I don't have a lift an am always in the rocks out here. Mine as been into the tranny pan bigtime. I just use a BFH and straighten it out until next time. It really only protects my pan from punctures. |
|
| Author: | Boiler [ Mon May 24, 2010 5:17 pm ] |
| Post subject: | Re: Skid plate issues |
If your skids bend once or twice, you might consider it a fluke, but if it happens again and again, reinforce it! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|