So about a week ago i debadged the back of my jeep- came off very clean (I used a hairdryer and dental floss, and cleaned it off with a adhesive-remover I found in the Auto Section at Walmart. Looks spotless.

Well tonight, i decided to do the front- I used a heat gun (carefully, kept it moving) and pried the letters off, and used the adhesive remover again, and used windex afterwards to clean it.

So the back looks spotless, but the front letters have a dull ring around where each of the letters went? It looks like a faded outline sort of- How can I remove this? I scrubbed the front with a washrag and the windex but it wouldnt budge D:

_________________
2006 Jeep Liberty project
started june 3rd, 2010
{o} 2" OME Suspension Lift
{o} 4 Roof lights
{x} Trim Bumper
{o} 2 Way Autostart ; )
{o} Flowmaster Super 44 Exhaust(?)
{o} 5 Rowdy new tires(type?)
{o} Spidertrax Tire Spacers
{o} Sand & Repaint rims
{o} Defender Rack

current status: saving, saving...

Little rubbing compound, then wax good and forget it for a while. You'll always be able to see it some since the paint has faded but not as much as that area fades over time

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Gah, all right - 'ppreciate it.

_________________
2006 Jeep Liberty project
started june 3rd, 2010
{o} 2" OME Suspension Lift
{o} 4 Roof lights
{x} Trim Bumper
{o} 2 Way Autostart ; )
{o} Flowmaster Super 44 Exhaust(?)
{o} 5 Rowdy new tires(type?)
{o} Spidertrax Tire Spacers
{o} Sand & Repaint rims
{o} Defender Rack

current status: saving, saving...