MAN! I cannot get these things to let go. I'm letting them soak in some wd40 for a bit. I don't know if you guys run into this or if it's just me, but something always has to fight me and it's usually something normally really simple.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| removing wheel hub/knuckle? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=54200 |
Page 1 of 1 |
| Author: | gastip [ Mon Jul 12, 2010 1:48 am ] |
| Post subject: | removing wheel hub/knuckle? |
Hello all, I've torn my passenger side cv boot and I'm trying to replace the cv axle shaft. I've gotten the upper and lower ball joint nut removed and the bottom of the strut fork but that knuckle isn't coming off. I haven't tried beating the heck out of it yet with a BFH, but is that normal? Does it usually require a lot of persuasion? Thanks in advance for any advice! |
|
| Author: | ATXKJ [ Mon Jul 12, 2010 8:14 am ] |
| Post subject: | Re: removing wheel hub/knuckle? |
I never take the ball joint nut completely off - just loose - the spring is pushing it apart - you want to be able to control the release. 1 hit with a big hammer against the end of the A arm normally pops it loose, rare occasions a second hit - but you should not be 'beating' on it. |
|
| Author: | gastip [ Mon Jul 12, 2010 12:40 pm ] |
| Post subject: | Re: removing wheel hub/knuckle? |
Thanks ATXKJ for the reply! I'll give that a shot. |
|
| Author: | tommudd [ Mon Jul 12, 2010 1:48 pm ] |
| Post subject: | Re: removing wheel hub/knuckle? |
Most of the time one or two hits will knock them loose, I always take the nut(s) completely off then run them back on till the bottom of the ball joint bolt just shows then smack em! That way you know the threads are clean and the nut will come off easy |
|
| Author: | gastip [ Mon Jul 12, 2010 2:23 pm ] |
| Post subject: | Re: removing wheel hub/knuckle? |
MAN! I cannot get these things to let go. I'm letting them soak in some wd40 for a bit. I don't know if you guys run into this or if it's just me, but something always has to fight me and it's usually something normally really simple.
|
|
| Author: | tommudd [ Mon Jul 12, 2010 2:31 pm ] |
| Post subject: | Re: removing wheel hub/knuckle? |
WD 40 is just a water displacement not good as a penetrating fluid Also you have to hit them hard some times, When I'm doing a lift for someone I always tell them to walk outside and not listen as I "bang " their ride 
|
|
| Author: | Neal [ Tue Jul 13, 2010 12:58 am ] |
| Post subject: | Re: removing wheel hub/knuckle? |
Hey hi Paul 50/50 mix of acetone and tranny fluid is best for stuck parts- So when are you out for another run? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|