It is currently Thu Jun 11, 2026 11:01 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ] 
Author Message
 Post subject: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 12:27 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
Hello,

I offically joined the lifted club yesterday and loved it but now i have some new problems. First as i turn a hard turn it acts as if i have 4 wheel low locked in. And if i put it into a turn it acts like it won't even do it. Next this is i have some very heavily induced vibrations at about 40. I am swapping my tires to day and getting a full alignment to see if that solves my problems. But any other ideas would be greatly appreciated and thank you everyone ahead of time.

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 12:47 pm 
Offline
Moderator / Lifetime Member
Moderator / Lifetime Member

Joined: Thu Jul 07, 2005 5:49 pm
Posts: 27226
Location: NOW Southeastern Ohio/ Tanzania
Get an alignment before anything else.
I always get one right away and then in a few weeks again after it settles down

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 12:55 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
It is under way now do you think this will solve both my problems? AND EVERYONE SEE THIS THE NEWBIES FIRST ANSWER COMES FROM THE GREAT REV MUDD. :BANANA: :pepper:

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 1:08 pm 
Offline
Moderator / Lifetime Member
Moderator / Lifetime Member

Joined: Thu Jul 07, 2005 5:49 pm
Posts: 27226
Location: NOW Southeastern Ohio/ Tanzania
Should take care of it, after you lift and before it settles any your tires are pulled in at the top ( a lot) making it feel really hard to drive and steer. You'll be amazed at the difference afterwards ( if they get it done right)

Good luck and of course we need pictures sometime soon! :mrgreen:

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 1:17 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
Oh there will be pictures for sure shortly. Going down the chattoga river tomorrow night so it will probably be monay before i get pictures up. But thank you once again the guy at the shop took one look at my KJ and said he had never seen one lifted before. He seemed to be excited to work on it.

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Fri Sep 03, 2010 11:43 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Sun Feb 01, 2009 2:29 am
Posts: 5956
Location: Hillsborough, NC / Corolla NC
shouldn't be any vibrations, misalignment doesn't cause vibes, particularly at low speed, unless your driving on the edge of the rim :P

It may just be that you're not used to being able to feel your tires roll ;) brand new stiff springs will make you feel all sorts of things that you never felt

Get it aligned, and go from there

if it's subtle micro vibrations it's probably your driveline since the angles on the cv's and dshaft have all changed

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Sat Sep 04, 2010 1:48 am 
Offline
I live here
I live here
User avatar

Joined: Sun Jul 10, 2005 6:59 pm
Posts: 5839
Location: Aurora, CO
You may have lost one of your lead weights for tire balance or you didn't tighten the lugs properly. Definitely get a wheel alignment after 2-4 weeks of installing the lift (as long as you have been driving it regularly and not letting it sit for 2-4 weeks).

_________________
===
New KJ Gear - Desert Armor Flak

2004 Renegade Light Khaki - 4" JBA Lift - Rock Lizard Products: Komodo Dragon Rear Bumper, Prototype Winch-mount Front Bumper, Super Skink Sliders - All J's Super Tranny Skid II - 31" Firestone Destination AT's on Moab wheels - Cobra 75W CB w/ stock Antenna mod

[b]Retired, US Military


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Mon Sep 06, 2010 2:43 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
The alignment solved everything and when they put the new tires on i had to trim some off the bumper. But now just have alittle rub on the front sway bar and still have some more triming to do after my trip to the moutians. But i am sitting 23 inches from center hub up front and rear. And have already gotten quite a bit of compliments now for my front bumper and new A arms.

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Mon Sep 06, 2010 2:57 pm 
Offline
Moderator / Lifetime Member
Moderator / Lifetime Member

Joined: Thu Jul 07, 2005 5:49 pm
Posts: 27226
Location: NOW Southeastern Ohio/ Tanzania
:wink:
Glad it all worked out, I figured it would
:JEEPIN: :JEEPIN: :JEEPIN:

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Mon Sep 06, 2010 3:43 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
Here they are the first pictures while we were at camp waiting to go down the Chattoga.

Image

The trailer and the jeep where fully loaded on the way up there through the moutian I only had the passenger seat open and it had someone in it.

This is right after we all got off the river tired beatin but had so much fun and the full loaded KJ in the back ground ready to go again.

Image

And by the way my Jeep is black but right now she looks gray from the 50+ of dirt roads this weekend.

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Mon Sep 06, 2010 5:20 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Tue May 05, 2009 7:40 pm
Posts: 688
Location: ky
Glad it worked out,nice pics.

Oh,and the Redhead to 40601?

_________________
02 Sport,Frankenlifted,JBA arms,31/11.50/15 LTB,Aussie locker,204,000m
Image


Top
 Profile  
 
 Post subject: Re: Vibrations and Hard to turn after lift
PostPosted: Wed Sep 08, 2010 1:41 pm 
Offline
LOST Addict

Joined: Mon Jun 14, 2010 8:49 am
Posts: 1336
Location: Greenwood SC
She is on the way should be dropped off at your nearest grey hound bus station in 2 to 3 days. All you have to do is feed and water and you will have a happy red head in no time and the occasional beer doesn't hurt. :wink:

_________________
My CRD Build Thread
Soon to Come:more lights


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Google [Bot] and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com